Wednesday, September 15, 2010

Pictures and Settings Update

Hoeken's Twisted Form Study:

Datafusions' ball(ball()) again, in creepy fleshtone:

Thanks to the advice from sideburn and wajasn on the Makerbot wiki forum, my print quality has taken a jump upward. Here's the post.

I can confirm that the PID settings work as advertised:

P: 11
I: 0.35
D: 110

Heat up time to 220C is 9 minutes, stablized at ±4C within 12 minutes.

I've settled on Skeinforge settings:

0.35 layer thickness
1.7 Width/Thickness

30 Feedrate
230 Flowrate

No comments:

Post a Comment